Contents: Installation ⬇ Tightening torque ⬇
Remove the lower cover on the driver's side. Remove the safety support "arrow" in front of the clutch pedal (if it is installed). Remove the clutch pedal switch, if equipped. Disconnect the clutch master cylinder control rod from the clutch pedal.
The control rod of the master cylinder of the clutch drive booster is disconnected from the clutch pedal as follows: Insert the pliers into the recesses of the clutch pedal. Press the fastener and disconnect the clutch pedal from the clutch booster master cylinder. Press the return spring against the waterproof casing - in the direction of the arrow - and remove it from the support from the bottom side.
Installation
Insert the support (fastening) for the return spring "arrow 1" into the support bracket.
The support protrusion is located in the recess of the master cylinder of the clutch drive control booster "arrow 2". Install the return spring in the support (attachment point).
Press the return spring onto the support and fit it onto the clutch pedal bracket "arrow". Connect the clutch pedal to the clutch master cylinder. Build in a switch for the clutch pedal.
Install the safety support "arrow" in front of the clutch pedal. Remove the lower cover on the driver's side.
Tightening torque
| Design detail | Tightening torque |
| Safety support | 9 Nm |