1. 180 Nm and turn further by 135°: the turn can be performed in several stages, for example 90° + 45°; replace after disassembly; unscrew and tighten using the stop -T30004 (3415)-; there is no need to additionally lubricate the thread and flange
2. Crankshaft toothed pulley: there should be no oil on the mating surfaces of the pulley and crankshaft; installation is possible only in one position
3. 20 Nm
4. Guide roller
5. 20 Nm, and tighten by 45° (⅛ of a turn): replace after disassembly
6. Tension roller
7. Toothed belt: Before removing, mark the direction of the belt with chalk or a felt-tip pen; check the degree of wear
8. 100 Nm: when loosening and tightening, use the "T10172" stop with adapters -T10172/11; additional lubrication of the thread and flange is not necessary
9.9 Nm
10. Camshaft toothed pulley; there should be no oil on the mating surfaces of the toothed pulley and camshaft
11. Camshaft leash
12. 20 Nm
13. Guide roller
14. High pressure fuel pump
15. Hub: high pressure pump; there should be no oil on the mating surfaces of the toothed pulley and the hub
16. Toothed pulley of the fuel injection pump: there should be no oil on the mating surfaces of the toothed pulley and the hub
This material is published on the portal SkodaBook.ru
17. Nut: no need to additionally lubricate the thread and flange
18. O-ring: replace after disassembly; lubricate the coolant
19. Cooling system pump
20. Bolt