Contents: Cylinder head - torque and…⬇ Parts and assemblies of the camshaft…⬇ Camshaft housing - torque and…⬇
Caution! It is prohibited to remove the camshafts separately. During repairs, the entire camshaft housing is replaced as a whole.
1. Cylinder head gasket: install in the correct position: the part number faces the cylinder head
2. Centering sleeve, 2 pcs.
3. Cylinder head
4. Landing pins
5. Gasket: with mesh filter; inserted into the cylinder head
[Data taken from this portal: Skodabook.ru]
6. Gasket: replace
7. Camshaft housing
8. Bolt
9. Bolt: replace
Cylinder head - torque and tightening order
Note: Replace screws that are tightened to the specified angle.
Tighten the bolts in stages in the specified sequence.
Parts and assemblies of the camshaft housing
1. Landing pin
2. Gasket: with mesh filter; inserted into the cylinder head
3. Sealing ring: intake camshaft
4. Sealing ring: exhaust camshaft pulley
5. Camshaft housing
6. Bolt
7. O-ring: replace
8. Valve 1 of the valve timing regulator "N₂05"
9.8 Nm
10. Gasket: for cover
11. Lid
12. O-ring: replace
13. Hall sensor "G40"
14. 8 Nm
15. Sealing ring: for exhaust camshaft, gearbox side
16. Toothed pulley: for coolant pump
17. Bolt
18. 8 Nm
19. Lid
20. O-ring: replace
21. Gasket: replace
Camshaft housing - torque and tightening order
Note: Replace screws that are tightened to the specified angle.
Tighten the bolts in stages in the specified sequence.
