Cylinder head — external view (1.2 MPI engine) (Skoda Rapid NH1)

1. Fastening bolt tightening torque during installation 10 Nm + further tightening by 90°
2. Sealing ring
3. Camshaft position sensor
4. Fastening screw, tightening torque during installation 8 Nm
5. Fastening screw tightening torque during installation 10 Nm
6. Support
7. Lid
8. Exhaust camshaft
9. Camshaft support cover
10. Rocker arms
11. Hydraulic compensator
12. Valve mounting crackers
13. Valve spring retaining washer
14. Valve spring
15. Oil seal
16. Engine oil pressure sensor, tightening torque during installation 25 Nm
17. Valve
18. Cylinder head mounting bolt
19. Cylinder head assembly
20. Sealing ring
21. Fastening bolt, tightening torque during installation 20 Nm
22. Mounting eye
23. Camshaft drive sprocket
24. Bolts for fastening the camshaft drive sprockets, tightening torque during installation 50 Nm + tighten by an additional 90°
25. Intake camshaft
26. Cylinder head cover

Material published on the website SkodaBook

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

◀ Previous

Skoda Rapid 1: Petrol engines

Next ►

Camshaft Drive Sprockets — Removal and Installation (1.2 MPI Engine)
Valve timing control (1.2 MPI engine)
Timing chain housing — removal and installation (1.2 MPI engine)
Installing the timing chain tensioner (1.2 MPI engine)
Locking the hydraulic tensioner of the timing chain (engine 1.2 MPI)

Removal and installation the cylinder head (1.2 MPI engine)
Checking the technical condition of the timing elements (engine 1.2 MPI)
Removal and installation of timing camshafts (1.2 MPI engine)
Replacing the timing belt oil seals (1.2 MPI engine)
1.2 MPI Engine Assembly — Removal and Installation

Read similar articles on other Skoda models