Firmly press screwdriver "1" to plane "2" of sealing ring "arrow B". Hook and remove sealing ring "arrow A". Clean sliding and sealing surfaces.
Lubricate the mating surface of the balance shaft "2" with engine oil. Put a new lip seal "1" on the balance shaft. Inscription ("Outside") "arrow" must be facing outwards to be readable.
(Article reprinted from the website: «skodabook.ru»)
Caution! Risk of thread damage, The drive pulley screw has a left-hand thread.
Insert the mandrel "T10353/1" into the sealing ring "1" and using the screw -2- press it into the cylinder block until it stops, without allowing it to tilt. Install the toothed belt of the coolant pump drive.
