1. Adjusting washer "K1": determine the thickness
2. Large engagement lever "K1": together with large engagement bearing; replace when replacing dual clutch
3. Hinge support: for large engagement lever pos. 2; cannot be replaced
4. Small engagement lever "K2": replace when replacing the dual clutch
5. Adjusting washer "K3": determine the thickness
6. Upper part of the guide bushing; for small engagement lever pos. 7; removed and installed together with the lower part of the guide sleeve pos. 10
7. Small engagement lever "K2": remove and install together with the upper and lower parts of the guide sleeve pos. 6 and pos. 10; replace when replacing dual clutch
8. Spherical pin: for small engagement lever pos. 7; replace when replacing dual clutch
9. 8 Nm and turn 90° (¼ turn): replace
10. Lower part of the guide sleeve: for the small engagement lever pos. 7; removed and installed together with the upper part of the guide sleeve pos. 6.
Adjust the position of the clutch engagement bearing "K1 and K2"
First, it is necessary to determine the dimension "B". This dimension is necessary for both clutches "K1" and "K2".
Note: The following work steps are carried out "sequentially" and precisely.