1. KP
2. Spherical pin, 25 Nm: The original grease must be removed from the contact surface of the clutch release lever; lubricate with consistent grease "G 000 100"
3. Drive shaft sealing ring: replace
4. Guide bush: with vulcanized O-ring seal; if the O-ring is damaged, the guide sleeve and the ring are replaced together. Lubricate the guide sleeve in the area of the release bearing with grease "G 000 100"
5. Spring: Attached to the clutch release lever
[Source of the article web resource: SKODABOOK.ru]
6. Socket head screw, 20 Nm
7. Clutch release lever: The original grease must be removed from the contact surface of the clutch release lever. Lubricate the contact surface of the spherical journal with grease "G 000 100"
8. Release bearing: Do not wash the bearing, just wipe it clean; replace the bearings. Lubricate the bearing surfaces of the clutch release lever with "G 000 100" grease
9. Slave cylinder: Lubricate the tappet head with grease "G 000 100"
10. Flange screw, 20 Nm
11. Mounting screw: secures the clutch release lever when installing the gearbox; unscrew after installing the gearbox and clutch slave cylinder. Note: If the mounting screw pos. 11 is missing, you can use the M8 x 35 screw