Contents: Removal ⬇ Installation ⬇
Removal
1. Remove the rear door trim panel (for more details, see the relevant section in this chapter).
2. Fix the door glass using pieces of adhesive tape.
3. Disconnect the wiring harness connector (4) shown in the figure below.
4. Unscrew the mounting screws (2) as shown in the figure below.
5. Remove the window lift motor together with the control unit (1) from the supports and disconnect it from the drive drum (3), as shown in the figure below.
Installation
Attention: Must be coded (initialize), when replacing, a new electric motor for the window lifter servo.
1. Install the window lifter servo motor (1) onto the drive drum supports (3) as shown in the figure below. Raise the door glass and carefully lower it until the motor engages with the drive drum.
2. Install and tighten the mounting screws (2) shown in the figure below to a tightening torque of 3 Nm.
3. Connect the wiring harness connector (4) as shown in the figure below.
4. Initialize the window lifter servo motor (if a new electric motor has been installed).
5. Further installation is carried out in the reverse order of removal.
