Removing
1. Remove rear door glass (for details, see the relevant section in this chapter).
2. Remove the outer seal.
3. Remove the protective film from the mounting bolt (3), shown in the figure below.
4. Unscrew the fastening bolt (3), shown in the figure below.
5. Gently and gradually disconnect and remove the rear door glass guide.
6. Move the seal on the inside of the rear door fixed glass along the door frame until the special tool can be installed in the positions shown in the figure below.
7. Install special tool (Т30116) (2) between the fixed glass panel and the door frame, as shown in the figure below.
8. Detach the fixed glass (1), gently prying it away from the door frame using the tool as shown in the figure below.
9. Install special tool (Т30116) (2) between the fixed glass panel and the door frame, as shown in the figure below.
10. Detach the fixed glass (1), gently prying it away from the door frame using the tool as shown in the figure below.
11. Gently press on the glass and remove from the door assembly.
Installation
1. Install the fixed glass on the door frame.
2. Install the mounting bolt and fix it.
3. Press the seal on the outside of the door frame to install the fixed glass properly.
4. Screw in and tighten the fastening screw (3) with the required tightening torque. Tightening torque 8 Nm.
6. Install the protective film of the fastening screw (3).
7. Further installation is carried out in the reverse order of removal.