Removing
1. Disconnect the rear door glass guide seal (1) from the inside of the door frame, as shown in the figure below.
2. Remove the guide (1) from pillars in the door (arrow b), as shown in the figure below.
3. Detach both retaining clips (3) guide (1) door glass as below picture.
4. Detach the glass guide (1) from the door frame (arrows a), as shown in the figure below.
Installation
1. Seal all exposed parts of the rear door glass guide that are susceptible to damage with adhesive tape. The length of the pieces of adhesive tape should be 40 mm, width - 10 mm.
2. Install the rear door glass guide into the supports (1), as shown in the picture below (arrows a).
3. Press the door glass guide (1) evenly around the entire perimeter to the rear door frame (2), as shown in the figure below.
4. Press the sealing parts of the door glass guide against the door frame again.
5. Install the fixing clip (3), as shown in the picture below (arrow b).
Note. The cut of the retaining clip must be directed towards the inside of the vehicle, as shown in the figure below.