Removing
1. Remove rear door trim panel (for details, see the relevant section in this chapter).
2. Remove the tailgate cover (for details, see the relevant section in this chapter).
3. Unscrew the fastening screws (4), shown in the figure below.
4. Remove the lock (1) out the door (2), as shown in the figure below.
5. Disconnect the Bowden cable from the mounting bracket. For this:
Turn the Bowden cable (5) 45°and remove it from the bracket (arrow a), as shown in the figure below.
Rotate the Bowden cable arrow «b» until it becomes possible to remove it from the grip on the door lock (1) (arrow with), as shown in the figure below.
6. Disconnect the Bowden cable from the internal control mechanism. For this:
Turn the Bowden cable (6) at a 45°angle and remove it from the bracket as shown in the figure below.
turn the rope (arrow d) until it becomes possible to remove it from the grips on the lock (1) (arrow e).
Installation
1. Installation is made in reverse order to removal.
2. Install and tighten the fastening screws (4) with a tightening torque of 18 Nm.
Note. Check the functioning of the door lock, if necessary, adjust the Bowden cables properly, otherwise the door may not open after closing.