Removing
1. Remove rear door trim panel assembly (for details, see the relevant section in this chapter).
2. Raise the door cover at the bottom of the door (1), as shown in the figure below.
3. Pull the door cover down (1), in the direction of the arrow to detach it from the door (4), as shown in the figure below.
Note.
- If necessary, it is necessary to stretch the Bowden cable (2) through the seal (3) in the door cover (1), as shown in the figure below.
- Cables are fixed in holders (5).
Installation
1. Pull the Bowden cable (2), through the door cover (1) and fix the duster (3), as shown in the figure below.
2. Install the cover (1) in the door (4), as shown in the figure below.
3. Press the cover in its lower part against the door.
Note. Bowden cable fixed in holders (5), shown in the figure below.