Removal
1. Turn off the ignition and disconnect all electrical consumers.
2. Carefully detach the panel (3) from the rear door trim panel using the special tool (T10383, 3409), as shown in the figure below.
3. Unscrew the fastening screws (2) shown in the figure below. The tightening torque of the fastening screws during installation is 4.5 Nm.
4. Turn the nut (4) 90° on the bottom using an SW10 open-end wrench to release the fastening element.
5. On vehicles with manual window lift: Remove the spacer ring (1) in the direction of the arrow, then remove the rear door window lift handle as shown in the figure below.
Attention. When detaching the front door trim panel, there is a high probability of damaging the fastening elements. To avoid this, it is necessary to detach the panel in the strict sequence shown in the figure below, using a special tool.
(The original article is available on skodabook.ru)
6. Disconnect the rear door trim panel from the fastening elements, following the sequence shown in the figure below, using a special tool (T10383/1, T10383).
7. Move the rear door trim panel upward and remove it from under the rear door glass inner seal.
8. Push the Bowden cable (3) into the door trim panel, releasing it from the door lock release control mechanism (2), in the direction of the arrow as shown in the figure below, and disconnect its end (1).
9. Disconnect the wiring harness connectors from the front door trim panel.