Removal and installation the front seat side covers (Skoda Rapid NH1)

Removal

1. Remove the front seat assembly (for more details, see the relevant section in this chapter).

2. Unscrew the fastening screw (1) shown in the figure below. Tightening torque of the fastening screw during installation: 1 Nm.

3. Remove the cover (5) from the seat back angle adjuster handle (4) as shown in the figure below.

4. Remove the seat back angle adjustment lever (4) shown in the figure below.

Note: The seat back angle adjustment lever cannot be removed from the drive mechanism shaft without damage.

5. Open the front seat side cover assembly latch (2), then press on the support

6. Detach the side cover (2) from the seat frame (1), then remove it completely, as shown in the figure below.

Installation

Installation is carried out in the reverse order of removal.

Note: Before installation, check the integrity of all fastening elements. If necessary, replace damaged fastening elements with new ones.

(View the original on the website www.skodabook.ru)