Removing
1. Unscrew the fastening screw (8) and remove the tailgate release lever (7), as shown in the figure below. The tightening torque of the fastening screw during installation is 2.5 Nm.
2. Disconnect the fixing clips (5) tailgate trim panel.
3. Remove the trim panel from the car (6), as shown in the figure below.
4. Remove the rear window wiper motor cover (4), as shown in the figure below.
5. Remove expansion rivets (4), shown in the figure below.
6. Loosen the rivet nuts (2).
7. Pull and remove the tailgate opening handle (1), shown in the figure below.
Installation
Installation is carried out in the reverse order of removal.
Note. Before installing the cladding panel, it is necessary to check all fastening elements and, if necessary, replace these elements with new ones.