Removal and installation the clutch booster master cylinder (Skoda Fabia 5J)

Contents: Installation ⬇ Tightening torque ⬇

Remove the upper engine cover. Before disconnecting the battery in vehicles with a car radio equipped with an anti-theft jamming code, you must know this code. With the ignition off, disconnect the wire connecting the battery terminal to the ground (body) of the vehicle. Remove the battery and battery holder. Remove the air filter. After removing the additional hose "A" leading to the hydraulic brake drive receiver, plug it. Remove the safety clip "B" from the clutch booster master cylinder. Remove the pipe and hose line "C" from the master cylinder of the clutch control booster and seal it. Remove the lower cover on the driver's side.

Remove the safety support "arrow" in front of the clutch pedal (if it is installed). Remove the clutch pedal switch, if equipped.

Important: To remove the clutch master cylinder, the clutch pedal assembly must be completely removed. However, before you begin removing it, you need to disconnect the clutch booster master cylinder from the clutch pedal.

Disconnect the clutch master cylinder control rod from the clutch pedal.

The control rod of the master cylinder of the clutch drive booster is disconnected from the clutch pedal as follows: Insert the pliers into the recesses of the clutch pedal. Press the fastener and disconnect the clutch pedal from the clutch booster master cylinder. Remove the return spring. Remove the return spring support from the mount.

Having unscrewed the nuts "arrow 1", completely remove the clutch pedal mechanism "arrow A" with the master cylinder of the clutch drive control booster. Unscrew the pedal stop. Master master cylinder of the clutch actuator booster.

Installation

Installation is carried out in the reverse order of actions, and the following instructions must be observed. Mount "A" must be located on control rod "B" of the clutch drive booster master cylinder.

For correct installation, press the clutch pedal against the front bulkhead separating the engine bay from the passenger compartment "arrow direction", ensuring proper locking.

Build in a switch for the clutch pedal. Install the safety support "arrow" in front of the clutch pedal. Remove the lower cover on the driver's side. After installing the clutch booster master cylinder, bleed the air from the clutch system.