Note. The information below only applies to pre-1998 models. At the time of writing this manual, information on later models was not available.
1. Gently prying with a small screwdriver, remove the fog lamp cover from the front side of the bumper.
2. Turn out fixing screws and release assembly of a headlight from a bumper. Disconnect the electrical wiring and remove the headlight from the vehicle.
3. Release a fixing clamp and take a lamp from a headlight.
4. Try not to touch the bulb of the new lamp with bare fingers - use a paper towel or napkin. Accidentally left stains can be removed by wiping the flask with methanol.
5. Install the new lamp, making sure the reflector fits properly and the assembly is secure.
6. Connect the electrical wiring, then install the headlamp assembly into the front bumper. Tighten the fixing screws firmly. Then reinstall the trim panel.