B-pillar trim panel (lower part) — removal and installation (Skoda Kodiaq NS7)

Removal

1. Remove the upper part of the B-pillar trim panel.

2. Disconnect the upper part of the lower trim panel from the clamps on the central body pillar.

3. Lift the rear part of the lower A-pillar trim panel or remove the panel assembly.

4. Disconnect the B-pillar trim panel (1) from the clamps (2) by moving it upwards to remove it from the guides and the wheel arch trim panel.

5. Release the lower part of the center pillar trim panel from the seat belt, pull the belt through the hole in the panel (2), and then remove the trim panel assembly.

Installation

Installation is carried out in the reverse order of removal.

• After installing the trim panels, make sure that the double door seal fits properly against them.
• Check and ensure that the lower B-pillar trim panel is connected and secured to the lower A-pillar trim panel and the wheel arch trim panel.

Note: Before installing the trim panel, check all fastening elements and replace them with new ones if necessary.

Note: After installing the trim panel onto the pillar, check to ensure that the trim panel is securely fastened to the rear door and tailgate seals.