Seal and stops for rear lid
1 - adjusting emphasis on the body; 2 - adjusting emphasis of the cover; 3 - bolt; 4 - bolt; 5 - placement of stops; 6 - protective foil; 7 - seal; 8 - vulcanization seal seal; 9 - luggage compartment cover
Decorative luggage compartment panel and pull handle
1 - clamp; 2 - handle; 3 – bolt ST 4.8x13; 4 - panel; 5 - emphasis
Adjustment stops are located in five places along the contour of the luggage compartment lid. They allow you to accurately fit its surface to the surface of the body. The cover in the body frame is sealed along the contour with a rubber tubular seal fixed to the wall with elastic steel brackets. The seal is bonded by vulcanization and this seal is located in the middle of the bottom wall of the frame.
Due to the large tilting angle of the lid, there is a handle on the right side of the lid, with which the lid can be pulled. It is screwed with a special bolt to a plastic bracket and threaded through the upholstered panel. The panel closes all the mechanisms mounted at the bottom of the cover. cover panel (like the door panel) is a three-dimensional stamping of modified polypropylene. All necessary holes are pre-punched in the panel. On the inside there are holders for caps, with which the panel is attached to the cover.