Removal and installation
Removal
1. Remove the top engine cover assembly.
2. Open the thermal insulation cover (4) shown in the figure below.
3. Disconnect the wiring harness connector (3) shown in the figure below.
4. Unscrew the mounting screw (1) and remove the differential pressure sensor from the holder (2), as shown in the figure below.
[Text copied from this resource: Skodabook.ru]
5. Remove the bracket (8) from the support surface (7).
6. Spray the sensor with solvent before removing it.
7. Loosen the mounting clamp (10) shown in the figure below.
8. Carefully disconnect the hose from the fitting in the longitudinal direction (the hose must be disconnected from the differential pressure sensor with extreme care).
Installation
Installation is carried out in the reverse order of removal.
Note:
- Before installing the sensor, it is necessary to blow out the differential pressure sensor pipes with compressed air in the direction of the particulate filter (this way the condensation will be removed).
- Be extremely careful when connecting hoses.
- When connecting hoses, it is imperative to use special spring clamps.