Engine Oil Cooler (2.0L Engine) — removal and installation (Skoda Kodiaq NS7)

Removal

Note: Use extreme caution as the coolant in the system is under pressure. If the engine is hot, before starting work, it is necessary to relieve excess pressure by removing the expansion tank cap.

1. Drain the coolant into a pre-prepared container (for more details, see the relevant section in the chapter "Cooling system").

2. Remove the accessory mounting bracket.

3. Unscrew the mounting bolts (4) and (5), then remove the engine oil cooler (3) together with the sealing ring (2), as shown in the figure below.

3. Unscrew the mounting bolts (4) and (5), then…

[Text taken from this website: SKODABOOK.RU]

Installation

Installation is carried out in the reverse order of removal.

Note: Always replace gaskets and O-rings after disassembly.

1. Install the engine oil cooler (3) together with the new O-ring shown in the figure above.

2. Install the mounting bracket for additional attachments.

3. Fill the cooling system with coolant.

4. Fill the lubrication system with fresh engine oil.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Eleonora Afanasyeva

◀ Previous

Skoda Kodiaq 1: Lubrication system (petrol)

Upper Oil Pan (2.0 Engine) — removal and installation
Oil pump (2.0L engine)
Engine oil pressure check valve
Engine oil pressure sensor (pressure relief line)
Engine oil pressure sensor

Read similar articles on other Skoda models