Remove the front door trim. Remove the door glass. Remove the window lifter motor. Loosen the nuts "3". Unlock the cable reel locks -see arrows d- and push them into the door. Push the window lifter "1" into the door and turn it slightly in the direction of -arrow a-. Remove the window lifter through the opening in the door "arrow b" and "arrow c".
Installation
Insert window lifter "2" through the opening in the door "arrow a". Bring the window lifter to its installation location "arrow b". Push the threaded studs of the window lifter "arrow c" through the doors and tighten the nuts "4". Tightening torque: 8 Nm. Insert drum "1" into the door openings until the latches -arrow d- are fixed.
Removal and installation the glass guide
View the original on the website skodabook.ru
Note: When dismantling, do not bend the glass seal!
Remove the outside mirror. Lower the door glass to the lowest position. Disconnect the glass guide from the pillar and unscrew screws "2".
Remove the trim from pillar B "1".
From the inside, move the working edge of the glass guide "1" away from the door flange. Evenly detach the glass guide "1" from the door flange along the entire perimeter "arrow a". Remove the glass guide "1" from the fasteners -arrows b-.
Installation
Insert the glass guide into the fasteners "arrow a". Press the glass guide evenly along the entire perimeter to the door flange "3". Press the glass guide to the door flange "3" from the inside. Disconnect the glass guide in the cavity of the pillar. Install the lining of the pillar "1" and screw in the screws "2" (2.5 Nm). Press the glass guide to the door flange in the cavity of the pillar.
Note: When installing the glass guide, ensure that it fits evenly (wind noise).