Installation
Installation in reverse order. Insert the glove box with the upper edge over the stop of the bracket. Insert cable -1- into loop on front panel -2-. Insert the lower part of the glove box into the hinges on the front panel. Press the bottom of the open glove box in the direction of the arrow until the glove box is locked in the hinges.
Note: Before installation, check all fastening elements for damage and replace if necessary.
Removing and installing the glove box bracket on the passenger side
Remove the glove box from the front passenger side.
Screw in screws -3- (1.5 Nm). Pull towards passenger compartment and detach bracket -2- from front panel -1-. Disconnect connector from infotainment control unit (depending on vehicle configuration). Disconnect the glove box cooling inlet hose and remove the bracket.
Installation
Installation in reverse order.
Note: Before installation, check all fastening elements for damage and replace if necessary.