Note: Observe the installation instructions. After replacing the brake pads, press the brake pedal firmly several times with the vehicle stationary until the brake pads are in their operating position. Use a brake fluid filling and bleeding device, such as "K4S 5234", to pump out the brake fluid from the reservoir. Before removing the brake caliper or before disconnecting the brake pipe from the brake caliper, insert a brake pedal pressing device, such as - VAG 1869/2-.
1. Bolt, 8 Nm
2. ABS speed sensor: before replacing the sensor, clean the inner surface of the hole and lubricate with heat-resistant thread paste "G 052 112 AZ"
3. Bolt, 90 Nm + 90°; replace after each removal
4. Brake pipe
5. Subframe
6. Handbrake cable
7. Protective shield
8. Suspension neck
9. Bolt, 30 Nm + 90°: replace after each removal
10. Wheel hub with wheel hub bearing
11. Bolt, 200 Nm + 180°: replace after each removal
12. Brake disc: if worn, replace on both wheels of the axle; to remove, first unscrew the brake caliper screws
13. Bolt, 8 Nm
14. Dust cap: Replace after each removal
15. Brake shield with guide pins and protective caps
16. Brake pads: Replace on both wheels of the axle. Follow the instructions for replacing the pads
17. Brake caliper: Do not unscrew the brake line to replace the brake pads. After repair or replacement, the parking brake must be adjusted. Follow the instructions for replacing the pads
18. Bolt, self-locking, 35 Nm: replace after each removal