Note: Follow the instructions for replacing the brake pads. After replacing the brake pads, press the brake pedal firmly several times with the vehicle stationary until the brake pads are in their operating position. Use a brake fluid filling and bleeding device, such as "VAS 5234", to pump out the brake fluid from the reservoir. Before removing the brake caliper or before disconnecting the brake pipe from the brake caliper, install a device for pressing the brake pedal, such as, "V.A.G 1869/2".
1. Bolt, 12 Nm
2. Brake disc: ventilated; replacement must be done on both wheels of the axle; to remove, first unscrew the brake caliper screws
3. Bolt, 4.5 Nm
4. Brake pads: Replace on both wheels of the axle. Follow the instructions for replacing the pads
5. Brake caliper: When replacing brake pads, do not disconnect the brake line. Follow the instructions for replacing the pads
6. Guide pin, 30 Nm
7. Cap: remove
8. Brake hose with ring nipple and hollow screw, 35 Nm
9. Wheel hub bearing housing: with integrated brake shield
(Information presented on the website: skodabook)
10. ABS speed sensor: before replacing the sensor, clean the inner surface of the hole and lubricate with heat-resistant thread paste "G 052112 AZ"
11. Bolt, 8 Nm
12. Wheel hub with wheel hub bearing: The ABS sensor toothed disc is built into the wheel hub
13. Protective shield