1. Shield
2. Screw, 12 Nm
3. Wheel hub with bearing: The magnetic ring of the ABS sensor is installed in the hub; repairs not provided
4. Bolt, 200 Nm, then turn 180°: replace after each removal; when loosening and tightening the bolts, the car should not stand on its wheels
5. Screw, 8 Nm
6. Front Speed Sensor: Before installing the sensor, clean the inner surfaces and apply a small amount of plastic grease to the sensor
7. Steering knuckle: different designs depending on the model
8. Steering knuckle: different designs depending on the model
9. Bolt, 70 Nm and turn 90° further: replace after each removal
10. Drive shaft: When working, the drive shaft should not hang down, this may cause damage to the inner joint; before installing the outer joint into the hub, apply a small amount of assembly grease to its splines