1. 60 Nm and tighten by 90° (¼ vol.): replace after disassembly
2. Flywheel: check the functioning of the dual-mass flywheel; installation is possible only in one position; consider catalog number
3. Input rotor: Engine speed sender -G28-
4. Engine speed sender -G28-
5. 4.5 Nm
6. Landing pin, 2 pcs.
7. Intermediate plate: prevent damage or bending during reinforcement work
8. Crankshaft cover on gearbox side: with lip seal
9. Bolt
Install intermediate plate
Position intermediate plate on crankshaft cover -upper arrow- and on dowel sleeves of engine flange -lower arrows-.
Crankshaft cover on the gearbox side - torque and tightening order
Tighten the bolts step by step in the sequence shown.