1. Cylinder block
2. Cylinder head gasket; after replacement, replace the coolant and oil in the engine; consider catalog number
3. Cylinder head: place the removed cylinder head only on a foam pad, otherwise the glow plugs may be damaged; modification is prohibited; before installation, check the presence in the cylinder block of both centering sleeves for centering the cylinder head; after replacement, replace the coolant and oil in the engine; consider catalog number
4. Mounting pin: camshaft housings
5. Bolt: replace after disassembly
6. 20 Nm
7. Eye for hanging the engine
8. Spacing ring: replace if damaged
9. O-ring: replace after disassembly; lubricate coolant
10. Coolant temperature sender -G62-
11. Hairpin
12. Mounting pin: camshaft housings
13. Union: coolant hoses
14. 10 Nm
15. O-ring: replace after disassembly
16. Pin: intake manifold with intercooler
17. Centering sleeves
Cylinder head gasket marking
Catalog number = - arrow 1 -
Holes -arrows 2- (ignore).
Holes -arrow 3-
Note: The thickness of the cylinder head gasket to be installed depends on the protrusion of the pistons. If only the cylinder head gasket is replaced, install a new gasket with the same marking.
Cylinder head - tightening torque and order
Note: Replace screws that are tightened to the specified angle.
Tighten the bolts step by step in the sequence shown.