Note: Lubricate all bearing and contact surfaces with grease "G 000 450 02".
1. Gear shift cable; disconnect from the shift lever guide on the gear shift mechanism; press into the guide of the gearshift lever on the gearshift mechanism; connect to the drive cable clamp pos. 11; attach to gear selector cable using bandage; adjust after installing the switching mechanism:
2. Gear selection cable; disconnect from the angle on the gear shift mechanism; press into the square on the gear shift mechanism; connect to the drive cable clamp pos. 10; attach to the gear shift cable using a bandage; adjust after installing the switching mechanism:
3. Gear selector cable bushing
4. Gear shift housing
5. Safety brackets: do not damage when dismantling the cables; is subject to mandatory replacement
6. 20 Nm: 3 pcs.; for drive cable counter support
7. Drive cable counter support: plastic or metal
8. Tip: 3 pcs.; installation of the drive cable counter support relative to the gearbox
9. Bushings: 3 pcs.
10. Cable arrester for: gear selector cable on locking lever; adjust after installing the shift mechanism: do not confuse, the drive cable lock for the gear selector cable to the intermediate lever is different from the lock for the shift cable to the gear shift lever; can be installed in combination with a plastic locking lever; disconnect from the plastic intermediate lever; press into the plastic intermediate lever
11. Cable arrester for: shift cable to gear shift lever; adjust after installing the shift mechanism: do not confuse, the drive cable lock for the gear selector cable to the intermediate lever is different from the lock for the shift cable to the gear shift lever
12. Retaining rings: must be replaced; on the drive cable retainer for the gear selection cable to the intermediate lever are not required if the intermediate lever is plastic
13. Lock washer: must be replaced; not required if the intermediate lever is made of plastic
14. Support bushings: not required if the intermediate lever is made of plastic
15. Intermediate lever: adjust after installing the shift mechanism: can be made of plastic or metal; the metal intermediate lever is mounted on the support bushings pos. 14 and secured with a lock washer pos. 13; if the intermediate lever is plastic, neither the support sleeve pos. 14 nor the lock washer pos. 12 and 13 are required
16. Crawler
17. Gear shift lever; with counterweight; install so that the interrupted pitch of the teeth fits the gear shift rod; adjust after installing the switching mechanism:
18. 23 Nm: must be replaced
Selecting the appropriate drive cable arrester
The holes in the drive cable arresters have different diameters.
 |
 |
Diameter of the bolt for fixing the arrester for the gear shift cable
 |
 |