Contents: Shift lever/intermediate lever…⬇ Installation position of the bandage…⬇ Intermediate lever made of plastic ⬇ Remove the gear selector cable…⬇
When installing the gear shift lever, make sure that the gap between the teeth "see arrow A" matches the interrupted pitch of the gear shift rod teeth "see arrow B".
Shift lever/intermediate lever installation position
1. Gear shift lever with damping counterweight.
2. The intermediate lever enters above the slider "see arrow" into the guide rail of the gear shift lever.
Installation position of the bandage for fastening the drive cable
Wrap the bandage "see arrow" crosswise around the drive cables and secure as shown.
Intermediate lever made of plastic
Removal and installation the plastic locking lever
Pull the locking mechanism forward as far as it will go in the direction of arrow 1 and then lock it by moving it to the left in the direction of arrow 2. To prevent damage to the gear selector cable, separate the drive cable arrester from the gear selector cable before removing it. The gear shift lever is in neutral.
(Article source: this website: www.skodabook.ru)
The intermediate lever is fixed with a lock "see arrow 1" in the gearbox cover
Carefully press the lock "see arrow 1" until it stops. Then move the intermediate lever in its support to one side and to the other (in the direction of management). At the same time, carefully remove the intermediate lever together with the drive cable arrestor "see arrow 2". Remove the drive cable lock "see arrow 2" only when the intermediate lever is removed.
Note: For installation, lubricate the bearings and sliding surfaces with grease "G 000 450 02".
Press the drive cable arrester onto the intermediate lever. Install the intermediate lever together with the drive cable arrester. The locking lug "see arrow 1" secures the intermediate lever. The drive cable arrester must be located behind the lock "see arrow 2".
The intermediate lever is fixed with a clamp "see arrow 1" in the gearbox cover
Pull the clamp "arrow 1" out of the hole on the intermediate lever. Then pull the intermediate lever together with the cable arrester out of its seat on the gearbox cover. Remove the drive cable arrester only when the intermediate lever is dismantled.
Note: For installation, lubricate the bearings and sliding surfaces with grease "G 000 450 02".
Press the drive cable arrester onto the intermediate lever. Install the intermediate lever together with the drive cable arrester. Secure the intermediate lever with clamp "A".
Remove the gear selector cable retainer from the plastic intermediate lever
The intermediate lever is removed. Insert a slotted screwdriver "A" between the bushing "B" and the intermediate lever.
Press the drive cable arrester. The intermediate lever is removed. The drive cable arrester can only be pressed onto the bushing - see arrow -. The drive cable arrester must move easily relative to the intermediate lever. It must be behind the locking lug.
