Contents: Removal ⬇ Installation ⬇
Removal
Control unit
1. The control unit is located on the bracket at the rear of the left wheel arch mudguard, next to the pre-heating system relay.
2. Disconnect the negative cable from the battery.
3. If equipped, release the fastening clips and remove the plastic cover.
4. Disconnect the electrical wiring, then remove the control unit from the support bracket.
Relay
Removal of the pre-glow system relay is carried out in accordance with the instructions given in paragraphs 2 through 4.
Installation
Installation is carried out in the reverse order. Make sure that the electrical wiring is securely connected.