Removing
Note.
- Necessary special devices, control and measuring devices, as well as auxiliary means:
- Container for collecting engine oil -WAS 6208-.
1. Remove the oil pan (for details, see the relevant section in this chapter).
2. Remove cover (1) from the oil pump. as shown in the picture below.
3. Remove fixing screws (arrows) oil pump shown in the figure below.
4. Remove the oil pump assembly from the drive chain as shown in the figure below.
Installation
1. Hooking the oil pump with the chain sprocket into the drive chain, install new mounting screws (arrows), shown in the figure below, applying a torque of 14 Nm + turn 90° (¼ turn).
Note. Tightening torque for intake manifold: 8 Nm.
2. Install oil pan (for details, see the relevant section in this chapter).