Contents: Removal ⬇ Installation ⬇
Removal
1. Remove the side turn signal repeater bulb (see Chapter 13 Section 12).
2. Remove the front bumper (see Chapter 8).
3. Remove the hood (Chapter 9).
4. Remove the front door (see Chapter 16).
5. Remove the nine bolts securing the wing.
6. Run a sharp knife around the perimeter of the wing, then remove the wing.
Installation
7. Before installing a new wing, clean the contact surfaces of the body and apply new sealant to them.
8. Install the wing and adjust its position, then insert the bolts and tighten them securely.
9. Install all remaining components in the reverse order of removal.