Headlights and car lighting system Skoda Fabia 2
The main headlights are with halogen lamps
General description Three types of headlights are installed A fixed headlight with a halogen reflector and a dual-filament H4 bulb. A fixed dual-halogen (lens) headlight with a single-filament H7 bulb. A cornering...
General description Three types of headlights are installed A fixed headlight with a halogen reflector and a dual-filament H4 bulb. A fixed dual-halogen (lens) headlight with a single-filament H7 bulb. A cornering...
Removal and installation headlights
Important: Removal and installation are shown using the left headlight as an example. Removal and installation of the right headlight are the same. To facilitate the fitting of the headlight during installation, it is...
Important: Removal and installation are shown using the left headlight as an example. Removal and installation of the right headlight are the same. To facilitate the fitting of the headlight during installation, it is...
Adjusting the headlight position
Important: To adjust the headlights, you must use a headlight adjustment device (regloscope). Low beam headlight, left (mirror image of the right device) 1 - Adjusting the low beam headlights (adjustment of position in...
Important: To adjust the headlights, you must use a headlight adjustment device (regloscope). Low beam headlight, left (mirror image of the right device) 1 - Adjusting the low beam headlights (adjustment of position in...
Switching the inner diaphragm of dual-halogen (with lens) headlights for right-hand traffic
To prevent blinding oncoming vehicles when driving in countries with right-hand or left-hand traffic, it is necessary to switch the internal diaphragm of the headlight. Methodology The technique is the same for both...
To prevent blinding oncoming vehicles when driving in countries with right-hand or left-hand traffic, it is necessary to switch the internal diaphragm of the headlight. Methodology The technique is the same for both...
Replacing the headlight retaining tabs
If the upper or lower headlight mounting tabs break off or become damaged, they can be replaced using a repair kit. This means there is no need to replace the entire headlight. Important: Before starting repairs, you...
If the upper or lower headlight mounting tabs break off or become damaged, they can be replaced using a repair kit. This means there is no need to replace the entire headlight. Important: Before starting repairs, you...
Removal and installation side turn signal repeaters
Important: The "arrow" lock is located on both sides of the vehicle, always in front. Remove 4 screws "4" (1 Nm) from the wing liner. Press out the side turn signal repeater from the inside with your hand. Remove cover...
Important: The "arrow" lock is located on both sides of the vehicle, always in front. Remove 4 screws "4" (1 Nm) from the wing liner. Press out the side turn signal repeater from the inside with your hand. Remove cover...
Rear grouped light devices
Assembly diagram 1 - Housing of the rear grouped lighting device. Removal and installation - Symbol identifying the position of the illustration; 2 - Direction indicator light bulb (PY21W, 12V, 21W); 3 - Left side - fog...
Assembly diagram 1 - Housing of the rear grouped lighting device. Removal and installation - Symbol identifying the position of the illustration; 2 - Direction indicator light bulb (PY21W, 12V, 21W); 3 - Left side - fog...
Removal and installation license plate lighting
Unscrew the supporting screws "arrows" (1 Nm) in the protective glass evenly. Remove the light fixture. Remove the incandescent light bulb (12 V, 5 W) from a pin chuck. Installation is carried out in the reverse order...
Unscrew the supporting screws "arrows" (1 Nm) in the protective glass evenly. Remove the light fixture. Remove the incandescent light bulb (12 V, 5 W) from a pin chuck. Installation is carried out in the reverse order...
Removal and installation the third brake light bulb and its light bar
Press the lamp slightly downward "arrow" to release the clips from the trunk lid openings. Swing the lamp down and release it from the retaining clip. Disconnect the plug connector. After pressing the clamps, remove the...
Press the lamp slightly downward "arrow" to release the clips from the trunk lid openings. Swing the lamp down and release it from the retaining clip. Disconnect the plug connector. After pressing the clamps, remove the...
Interior lighting — removal and installation
Carefully fold back the "arrow" and remove the glass diffuser. Remove the two screws "1" (2 Nm). Pull the interior body light downwards and disconnect the plug connectors. Incandescent lamp "2" without base 12 V, 5 W....
Carefully fold back the "arrow" and remove the glass diffuser. Remove the two screws "1" (2 Nm). Pull the interior body light downwards and disconnect the plug connectors. Incandescent lamp "2" without base 12 V, 5 W....
Removal and installation glove compartment lighting
Wedging a flat-head screwdriver under the glass "arrow" diffuser, carefully release the lamp. Disconnect the plug connector. Remove and replace the 12V, 3W incandescent bulb. Installation is carried out in the reverse...
Wedging a flat-head screwdriver under the glass "arrow" diffuser, carefully release the lamp. Disconnect the plug connector. Remove and replace the 12V, 3W incandescent bulb. Installation is carried out in the reverse...
Removal and installation the glove compartment light switch
Remove the middle panel. Open the glove compartment. Switch "1" should be released from the "arrow" latches using a small screwdriver and removed from the instrument panel. Disconnect the plug connector. Installation is...
Remove the middle panel. Open the glove compartment. Switch "1" should be released from the "arrow" latches using a small screwdriver and removed from the instrument panel. Disconnect the plug connector. Installation is...
Removal and installation trunk lighting
Wedging a flat-head screwdriver under the glass "arrow" diffuser, carefully release the lamp. Disconnect the plug connector. Remove and replace the 12V, 3W incandescent bulb. Installation is carried out in the reverse...
Wedging a flat-head screwdriver under the glass "arrow" diffuser, carefully release the lamp. Disconnect the plug connector. Remove and replace the 12V, 3W incandescent bulb. Installation is carried out in the reverse...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Read similar sections on other Skoda models
➧ Electrical equipment: Headlights and lighting Skoda Octavia 3 (2013-2019)
➧ Electrical equipment: Lighting and signaling Skoda Superb 2 (2008-2015)
➧ Electrical equipment: Lighting and signaling Skoda Yeti (2009-2017)
➧ Electrical equipment: Headlights and lighting Skoda Felicia (1994-2001)
Link to this section in various formats
TEXTHTMLBB Code
- General information
- User manual
- Maintenance
- Petrol engines 1.2 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Petrol engines 1.4 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Petrol engines 1.6 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Diesel engines 1.4 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Diesel engines 1.9 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Transmission
- Manual gearbox 02R
- Manual gearbox 02T
- Automatic gearbox 09G
- Cardan shaft
- Chassis (running gear)
- Front suspension
- Rear suspension
- Wheels and tires
- Brake system
- Steering system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Power devices
- Electrical circuits
- User manual
- Introduction to manual
- Governing bodies
- Salon equipment
- Driving and maintenance
- Power unit
- Engine repair
- Lubrication system
- Supply system
- Cooling system
- Exhaust system
- Transmission
- Mechanical gearbox 002
- Mechanical gearbox 02T
- Chassis (running gear)
- Front suspension
- Rear suspension
- Steering
- Steering gear without power
- Power steering
- Brake system
- Body and interior
- Body and interior repair
- Interior heating
- Electrical equipment
- Equipment and devices
- Ignition system
- Windshield wipers
- Electrical circuits
