Rear bumper - mounting pattern
1 – nut (4x); 2 – rear cross beam assembly; 3 – rear bumper assembly; 4, 5 – bumper extensions; 6 – overlay; 7 – spoiler; 8 – bumper cover
Rear bumper - connections and mounting material
8 – bumper cover; 9 – bumper; 10 – bolt; 11 – insert nut; 12 – piston
Under the rear bumper, just like under the front one, there is a steel frame.
The steel frame, the cross beam (2) is attached to the body with two nuts (1) on each side. On top of them, the plastic bumper itself (3) is applied, made of the same material and approximately the same design as the front bumper, and also in the color of the car. Along its entire lower part there is a black plastic spoiler (7), mounted at the manufacturer and secured with plastic pins.
The plastic bumper is secured at the top with six bolts. The two outer ones simultaneously attach the bumper extensions (4 and 5), located under the group lights. The next four bolts are covered with a plastic cover (6) after the bumper is mounted on the car. On the sides of the bumper, in the recesses, there are steel covers with welded nuts and are pulled to the body with only two bolts on each side; the bolts are installed from the luggage compartment.
There are three bolts at the bottom of the bumper and one more at the bottom on each side. All the bolts have a head with a lining and are screwed into plastic insert nuts. Along the entire length of the bumper, similarly to the front bumper, a black plastic bumper cover (8) is inserted, which is held on by elastic pins. This cover covers the mounting elements.