In the event of a power interruption to the solenoid to block the preselector lever (dead battery or defective fuse) or in the event of a faulty solenoid, it is impossible to move the preselector lever from the position «R», i.e. it is impossible to move the vehicle because the mechanism that locks the vehicle's transmission in the parking lot has entered the lock position.
1. Check the fuse.
2. Check battery voltage.
3. If even after this it is not possible to move the lever from the position «R», it is necessary to unblock the electromagnet in an emergency way. If the selector lever then moves back to the position «R», then it will remain in the position «R» blocked again.
Note.
- Necessary special devices, control and measuring devices, as well as auxiliary means:
- Dismantling tool -T30098-.
4. Open the ashtray on the middle panel.
5. Using a special tool (Т30098), remove the trim panel for the gear selector.
Note. Do not remove the selector lever head.
6. Depress the brake pedal or tighten the parking brake lever.
7. Yellow plastic wedge (A) should be pressed in the direction of the arrow (1), as shown in the figure below.
8. Press the button in the head of the selector lever and withdraw the selector lever (IN) in the direction of the arrow (2) out of position «R».
Note. If the selector lever is then moved back to the «R», then it will remain in the position «R» blocked again