Remove both mounting screws while holding the guide pin from turning.
Remove the brake caliper "1" and secure it with wire so that it does not pull the brake hose with its weight and does not damage it. Remove the brake pads "2" and "3" from the brake caliper "4".
Cleaning
Warning! Do not clean the brake system with compressed air, the resulting dust is hazardous to health! Thoroughly clean the brake pad guide surfaces on the brake shield, remove rust. Clean the brake caliper. Use only alcohol to clean the brake caliper.
(View the original on the website: skodabook.ru)
Installation
Before pressing the piston back into the cylinder using the piston return tool, it is necessary to pump out the brake fluid from the hydraulic brake drive reservoir. Otherwise, the brake fluid, if it was added, may leak out and cause damage. Press the piston back into the brake mechanism support using the piston return tool "T10145". Lightly lubricate the guide surfaces of the pads on the brake mechanism shield with grease from the repair kit.
Insert the brake shoes "2" together with the springs "1" into the mounting sockets on the brake shield "3". Carefully install the brake caliper on the brake shield.
Screw the brake caliper to the brake shield with new self-locking screws, holding the guide pins. Connect connector "1" of the brake pad wear indicator. Install the wheels.
Note: After each replacement of the brake pads, press the brake pedal firmly several times with the vehicle stationary until the brake pads are in their working position. After replacing the brake pads, check the brake fluid level.
Tightening torque
