1. Shift mechanism: Selector lever cable: The gear selector cable cannot be removed from the gear shift mechanism and is replaced together as a single unit; do not lubricate the selector lever cable; check and adjust. Selector lever and shift mechanism: with integrated wiring board for shift mechanism (selector lever -E313-); the tiptronic switch "F189", the selector lever sensor ECU "J587", the selector lever lock switch in position P "F319" and the selector lever lock magnet "N110" are integrated into the gearshift mechanism and cannot be changed individually; checked by self-diagnosis; adjust after installing the control lever drive cable, Adjusting screw selector lever cable: tightening torque 12 Nm
2. Nut, 8 Nm: for securing the shift mechanism to the body; 4 pcs.
3. Lock washer: replace
4. Gear shift lever: install so that the interrupted pitch of the teeth matches the gear shift rod
5. Nut, 20 Nm
6. Lock washer: replace
7. Drive cable counter support: for control lever drive cable
8. Screw, 20 Nm + turn 90° (¼ turn): replace; 2 pcs.; for fastening the cable support to the gearbox housing