1. Mounting bolts, tightening torque when installing 20 Nm
2. High pressure fuel pump
3. Screw for fastening the camshaft position sensor, tightening torque when installing 10 Nm
4. Camshaft position sensor
5. Mounting bolt, tightening torque when installing 20 Nm
6. Mounting eye
7. Mounting bolt, tightening torque when installing 8 Nm + tighten by 90°
8. Cylinder head cover
9. Mounting bolt, tightening torque when installing 10 Nm
10. Coolant temperature sensor
11. O-ring
12. Cylinder head gasket
13. Cylinder head
14. Hydraulic valve compensator
15. Engine oil pressure sensor
16. Rocker
17. Cylinder head bolt
18. Roller pusher
19. O-ring
Note.
- If the cylinder head is reused, all contact areas between the hydraulic tappets, rocker arms and cam friction surfaces must be lubricated with oil before installing the cylinder head cover.
- The plastic washers supplied to protect the open valves may only be removed before the cylinder head is installed.
- When replacing the cylinder head, it is also necessary to change the entire filling volume of the coolant.
- Before starting assembly work, all bearing surfaces and running surfaces must be lubricated with oil.