1.4-liter petrol engines of car Skoda Fabia 2

Engine code and number
Engine number The engine code and engine number can be found on the "arrow" sticker located on the timing gear cover. The engine code is also shown on the vehicle data plate and also on the front of the engine cylinder...

Additional instructions and assembly work for vehicles with air conditioning
Caution: Do not open the air conditioner coolant circuit. To avoid damage to the condenser, air conditioner refrigerant pipes and hoses, care must be taken not to overstretch, excessively bend or kink the pipes and...

Removal and installation the engine
Important: The engine is removed together with the gearbox in a forward direction. All cable clamps (bandages) that were loosened or cut during engine removal must be re-fastened in their original locations when the...

Unit support
Important: When installing, first insert all the support bolts and screw them in by hand at least 2-3 threads. The support bolts should be tightened in the sequence according to their numerical designation in the...

Disassembling and assembling the engine
Assembly diagram of a poly V-belt Engines without an air conditioning compressor 1 - 90 Nm + turn an additional 1/4 turn (90°), replace, the contact surface of the fastening screw must be free of oil and grease; 2 -...

Removal and installation a poly V-belt
Mark the direction of movement of the poly V-belt. Loosen the poly V-belt tensioner. Engines with air conditioning compressor To do this, tilt the tensioner to the side with a ring spanner "in the direction of the...

Removal, installation and tensioning the toothed drive belt
Remove the upper part of the timing belt guard. Remove the lower engine cover. Remove the wheel arch (fender) liner of the right front wheel. Mark the direction of movement of the poly V-belt and remove it. Adjust the...

Control of semi-automatic tension roller of toothed drive belt
Main drive tension roller check Mark the position of the tension roller indicator "arrow". Press the timing belt firmly with your thumb. The pointer should move. Release the pressure on the toothed drive belt and turn...

Removal and installation the cylinder block
Aluminum alloy cylinder block 1 - 10 Nm; 2 - Inlet manifold; 3 - Cylinder block; 4 - Knock sensor; 5 - 20 Nm, the tightening torque value affects the operation of the knock sensor; 6 - 60 Nm + turn an additional 1/4...

Removal and installation the cylinder head
Assembly diagram of the cylinder head Important: If installing a removable cylinder head, lubricate all contact areas between the hydraulic tappets, rocker arms and cam friction surfaces with oil before installing the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Petrol engines 1.8/2.0 l: Engine repair Skoda Octavia 3 (2013-2019)
➧ Power unit: Engine in car Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)