Fuel system (petrol, 1.2 l) of car Skoda Fabia 2

Removal and installation of fuel system components
Important: The fuel lines are connected using quick-release couplings that are released by pressing in a retaining ring. Fuel hoses on the engine can only be secured with spring clamps. The use of clamps or threaded...

Pumping fuel out of the fuel tank
Important: If the fuel pump fails, the fuel must be pumped out using a fuel suction device. Progress of work Remove the rear bench seat. Remove the fuel pump cover. Important: For vehicles with an additional independent...

Removal and installation the fuel pump
Premise The ignition must be turned off and the key removed from the ignition switch. The fuel tank can be filled to a maximum of 3/4 full. Removal Remove the cover under the rear seat. Disconnect the 4-pin plug...

Removal and installation the fuel gauge sensor «G»
Remove the fuel pump. Release and disconnect connectors "3" and "4". Using a screwdriver, lift retaining plates "1" and "2" and remove the fuel level sender "G" downward "arrow". Installation The fuel gauge sensor "G"...

Removal and installation the fuel tank
After opening the lid, unscrew the threaded plug of the fuel tank filler neck. Remove the plastic cover of the right rear wheel arch (fender). Unscrew the retaining bolts on the filler neck "arrows". Disconnect both...

Fuel pump shutdown by «crash» signal
Mode of action Vehicles with "Airbag" are equipped with a fuel pump shut-off device triggered by a "crash" signal (shock signal). If the Airbag system modules are activated while the vehicle is moving, the fuel pump is...

Electronic fuel management system (without mechanical connection of the accelerator pedal to the throttle valve)
Accelerator pedal module assembly diagram 1 - Bearing housing (support bracket); 2 - Plug connector, black, six-pin; 3 - Accelerator pedal module, with accelerator pedal position sensor "G79" and accelerator pedal...

Ventilation system with activated carbon
Assembly diagram of the activated carbon tank system 1 - Intake gas pipeline; 2 - Air bleed hose; 3 - Solenoid valve "N80", secured with a holder on the intake manifold, the valve is activated by clock pulses from the...

Layout of injection system assembly points
For engines with the letter designation BBM 1 - Valve injectors "N30...N32"; 2 - Solenoid valve 1 for activated carbon tank "N80", resistance value: 22 - 30 Ohm; 3 - Air valve; 4 - Engine speed sensor "G28", assembly...

Removal and installation of fuel injection system components
For engines with the letter designation BBM 1 - Connecting hose; 2 - Clamping bracket; 3 - Air filter; 4 - Suction pipe; 5 - Cable duct (Guide piece); 6 - Plug connector, only for vehicles with extended service...

Disassembly and assembly of the fuel distributor with valve injectors
Engine with the letter designation VVM 1 - Fuel supply hose connection pipe; 2 - Fuel distributor; 3 - O-ring; 4 - Injector valves -N30...N32-, installation with retaining clip fitted, lightly lubricate O-rings with...

Disassembling and assembling the intake manifold
For engines with the letter designation BMD 1 - 8 Nm; 2 - Throttle control mechanism "J338"; 3 - O-ring; 4 - from the electromagnetic valve 1 of the tank with activated carbon "N80"; 5 - From the regulating vacuum valve...

Removal and installation the engine control unit
Important: Before you begin replacing the engine control unit "J623", you must first find out the identification of the control unit and, thereby, also the coding of the existing control unit. When replacing, it is...

Removal and installation of exhaust system components
Important: Seals and self-locking nuts must always be replaced. 1 - Heat-protective casing; 2 - 8 Nm; 3 - Collector with built-in exhaust gas catalytic converter; 4 - Lambda probe "G39", 50 Nm, before the exhaust...

Ignition system
Removal and installation the ignition system 1 - Ignition coils with final power stage "N70", "N127", -N291 -; 2 - Plug connector for ignition coils with final power stage "N70", "N127","N291", four-pin; 3 - Plug...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Power and control system Skoda Rapid 1 (2012-2022)
➧ Petrol engines 1.8/2.0 l: Supply system Skoda Octavia 3 (2013-2019)
➧ Power unit: Power and exhaust system Skoda Superb 2 (2008-2015)
➧ Power unit: Power and control system Skoda Yeti (2009-2017)
➧ Power unit: Diesel power system Skoda Felicia (1994-2001)

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)