Cooling and lubrication system (diesel, 1.9 l) of Skoda Fabia 2

Removal and installation of lubrication system parts
Important: If, during engine repair, metal shavings or abraded metal particles are detected in the engine oil in increased quantities, then, to avoid further damage, it is necessary to thoroughly clean the lubrication...

Removal and installation the oil pan
Remove the lower engine cover. For engines with the letter designation BSW Unscrew the screw of the holder "3" and remove the air guide pipe, for which you should slightly pull out the retaining clips. For all cars...

Removal and installation the oil pump
Remove the oil pan and baffle. Unscrew screw "2". Remove the chain drive sprocket from the oil pump shaft. After unscrewing screws "1" and "3", remove the oil pump. Installation Installation is carried out in the...

Cooling system
Components of the cooling system located on the body Caution: When opening the expansion tank, hot steam or hot coolant may leak out. After covering the cork with a rag, carefully open it. If the engine is warm, the...

Components of the cooling system located on the engine
Engine with the letter designation BSW 1 - 15 Nm; 2 - Liquid cooling system pump, check for ease of movement, observe the assembly position; 3 - O-ring seal, replace; 4 - To the surge tank (at the top); 5 - Upper...

Coolant hose wiring diagram
Engine with the letter designation BSW BSW 1 - Radiator; 2 - Oil radiator; 3 - Coolant temperature regulator; 4 - Liquid cooling system pump; 5 - Cylinder block; 6 - Equalizing tank; 7 - Upper coolant pipe, bolted to...

Draining and filling coolant
Caution: When opening the expansion tank, hot steam or hot coolant may leak out. After covering the cork with a rag, carefully open it. Drain Open the cap of the coolant expansion tank. Remove the lower engine cover....

Removal and installation the liquid cooling system pump
Drain the coolant. Remove the timing belt. After unscrewing the support screws "1" of the liquid cooling system pump, remove the liquid cooling system pump "2". Remove the O-ring "3". Installation Installation is...

Removal and installation the thermostat
Remove the upper engine cover. Drain the coolant. Disconnect the coolant hoses from the connection pipe "2". After unscrewing the locking screws "1" of the connecting pipe, remove the connecting pipe "2" with the...

Removal and installation the radiator
Remove the front bumper. Remove the main front headlights. Drain the coolant. Disconnect plug connector "1" from coolant fan thermal switch "F18" and disconnect plug connector "2" on the fan housing. Disconnect the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Cooling system Skoda Rapid 1 (2012-2022)
➧ Power unit: Cooling system Skoda Octavia 1 (1996-2004)
➧ Power unit: Cooling system Skoda Superb 2 (2008-2015)
➧ Power unit: Cooling system (diesel 2.0 l) Skoda Kodiaq 1 (2016-2024)
➧ Power unit: Cooling system Skoda Yeti (2009-2017)
➧ Power unit: Cooling and heating Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)