Fuel system (petrol, 1.6 l) of car Skoda Fabia 2

Fuel system
Assembly diagram of the fuel tank with installed parts and fuel filter 1 - Fuel tank, when removing it, grasp it with the engine/gearbox removal and installation tool "VAG 1383 A", after replacing the fuel tank, air...

Removal and installation the fuel pump
The fuel tank can be filled to a maximum of 3/4. Remove the cover under the rear seat. Disconnect the 4-pin plug connector, fuel supply and return lines from the fuel pump flange. Important: To release the fuel lines,...

Removal and installation the fuel gauge sensor «G»
Remove the fuel pump. Release and disconnect wiring connectors "3" and "4". Using a screwdriver, lift retaining plates "1" and "2" and remove the fuel level sender "G" downward "arrow". Installation Fuel gauge sensor 2...

Removal and installation the fuel tank
If necessary, empty the fuel tank. After opening the lid, unscrew the threaded plug of the fuel tank filler neck. Remove the plastic cover of the right front wheel arch (fender). Unscrew the retaining bolts on the...

Removal air from the fuel system
Remove the cover in front of the fuse holder. Remove fuse #30 from the fuse holder. Connect the remote control device "VAG 1348/3A" using a combination of wires from the auxiliary measuring kit to the holder of fuse No....

Electronic fuel management system (without mechanical connection of the accelerator pedal to the throttle valve)
Accelerator pedal module assembly diagram 1 - Bearing housing (support bracket); 2 - Plug connector, black, six-pin; 3 - Accelerator pedal module, with accelerator pedal position sensor "G79" and accelerator pedal...

Ventilation system with activated carbon
Assembly diagram of the activated carbon tank system Important: Hose connections are secured with spring clamps. To install spring clamps, it is recommended to use spring clamp pliers. 1 - Intake gas pipeline; 2 - Air...

Fuel injection system repair
Assembly location diagram The parts marked with letters A and B are not shown in the figure. A - Accelerator pedal position sensor "G79" and accelerator pedal position sensor 2 "G185", in the footwell on the accelerator...

Removal and installation of exhaust system components
Important: When carrying out assembly work on the exhaust system, ensure that the exhaust system is mounted without pre-tensioning and that sufficient distance between the system and the body is maintained. If...

Ignition system
Assembly diagram of ignition system components 1 - Plug connector, black, four-pin, unlock using assembly tool "T101182"; 2 - Ignition coils with final power stage N70, N127, N291 and N292; 3 - Plug connector, black,...

Removal and installation ignition coils with final power stages
Attach the "T10094 A" puller to the ignition coil with the power output stage in the direction of the arrow. Slightly pull the ignition coil with the power output stage out of the cylinder head. Install the installation...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Power and control system Skoda Rapid 1 (2012-2022)
➧ Petrol engines 1.2 l: Supply system Skoda Octavia 3 (2013-2019)
➧ Power unit: Power and exhaust system Skoda Superb 2 (2008-2015)
➧ Power unit: Power and control system Skoda Yeti (2009-2017)
➧ Power unit: Fuel and exhaust system Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)