1.6-liter diesel engines for the car Skoda Fabia 2

Engine number and parameters
Engine number The engine number ("engine letter code" and "serial number") is located on the dividing (butt) seam between the engine and the gearbox. In addition, the "engine code letter" and "serial number" are also...

Removal the engine
Important: The engine is removed together with the gearbox in a downward direction. All cable clamps (bandages) that were loosened or cut during engine removal must be re-fastened in the same place when reinstalling the...

Engine installation
Progress of work Install the engine on the T10012 engine mount bracket. Installation is performed in reverse order, observing the following instructions. Important: When installing, replace the self-locking nuts and...

Removal and installation a poly V-belt
Assembly diagram of a poly V-belt for vehicles with engines with the letter designations BNM, BNV I - for cars without air conditioning; II - for vehicles with air conditioning; 1 - Holder, additional units; 2 - 45 Nm;...

Removal, installation and tensioning the toothed drive belt
Assembly diagram of a toothed drive belt 1 - Upper part of the toothed drive belt protective cover; 2 - Before removing the toothed drive belt, mark the direction of movement, check for wear, do not bend it too much; 3...

Installing and tensioning the toothed drive belt
The safety shaft is secured with a locking pin "MP1-301 (3359)". The crankshaft is secured with a locking device "T10050". The tension roller is secured with a locking tool "T10265" and is fixed in the rightmost...

Removal and installation the flange and flywheel sealing gasket
Assembly diagram of the flange and flywheel sealing gasket for vehicles with engines with the letter designations BNM, BNV Important: To carry out assembly work, it is necessary to secure the engine with the spore...

Removal and installation the G28 engine speed sensor (with BMS engines)
Remove the lower engine cover. After securing the coolant hoses to the oil radiator with MP7-602 (3094) clamps, disconnect the hoses from the radiator. Remove the oil filter holder. Loosen the "arrow" mounting screw...

Crankshaft, piston and connecting rod — removal and installation
Important: Before removing the crankshaft, ensure sufficient clearance for placement so that the sensor wheel does not contact or become damaged. Before assembly work, all bearing surfaces and working surfaces must be...

Cylinder head, valve drive
Removal and installation the cylinder head cover Remove the engine cover. Remove the upper boost air pipe "1" with connecting hose "2" "arrows". Important: Coolant hoses and fuel lines remain connected. Disconnect the...

Cylinder head — removal and installation
With the ignition off, disconnect the wire connecting the battery terminal to the ground (body) of the vehicle. Remove the upper engine cover. Remove the upper boost air pipe "1" with connecting hose "2" "arrows"....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Petrol engines 1.8/2.0 l: Engine repair Skoda Octavia 3 (2013-2019)
➧ Power unit: Engine in car Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)