Cooling and lubrication system (petrol, 1.2 l) of Skoda Fabia 2

Removal and installation of lubrication system parts
Important: If during engine repair the presence of metal shavings or an increased amount of worn particles is detected in the engine oil (for example, due to scuffing of the crankshaft and connecting rod), then it is...

Removal and installation the oil filter element
Having unscrewed the threaded plug to the height of the nose "a" "arrow" (or 3 turns if there is no nose there anymore), leave it in this position for at least one minute to allow the oil to drain from the filter...

Removal and installation of lubrication system parts
Removal and installation the oil pan Remove the lower engine compartment covers. Drain the engine oil. Remove the oil pan mounting screws. Separate the oil pan; if necessary, release it by tapping it with a rubber...

Removal and installation of cooling system components — assembly diagram
Important: Before starting repairs, the vehicle should be left to cool down; if necessary, the pressure should be released by carefully partially opening the plug with the pressure-reducing valve at the equalizing...

Components of the cooling system located on the engine
Assembly diagram of the thermostat 1 - 9 Nm; 2 - Coolant temperature regulator housing casing; 3 - From the lower radiator connection; 4 - Coolant temperature sensor "G62"; 5 - O-ring; 6 - Retaining clamp; 7-10 Nm; 8 -...

Draining and filling coolant
Caution: When opening the expansion tank, hot steam may leak out. After covering the cork with a rag, carefully open it. Open the coolant cap on the expansion tank. Remove the lower engine cover. Open the drain valve on...

Removal and installation the radiator
Drain the coolant. Disconnect the upper and lower coolant hoses from the radiator. Disconnect plug connector "1" of the fan thermal switch "F18" and plug connector "2" of the fan for additional cooling "V7". Cars with...

Removal and installation the liquid cooling system pump
Important: The integrated seal of the liquid cooling system pump must not be separated from the pump. If the liquid cooling system pump is damaged or leaking, it must be replaced along with the seal. Modification of the...

Removal and installation of cooling system components
Draining and filling coolant The coolant filling volume is approx. 5.0 l. Drain Open the coolant cap on the expansion tank. Remove the lower engine compartment covers. Place a catch basin under the engine. Turn the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Cooling system Skoda Rapid 1 (2012-2022)
➧ Power unit: Cooling system Skoda Octavia 1 (1996-2004)
➧ Power unit: Cooling system Skoda Superb 2 (2008-2015)
➧ Power unit: Cooling system (diesel 2.0 l) Skoda Kodiaq 1 (2016-2024)
➧ Power unit: Cooling system Skoda Yeti (2009-2017)
➧ Power unit: Cooling and heating Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)