Fuel system (petrol, 1.4 l) of car Skoda Fabia 2

Removal and installation of fuel system components
Important: The fuel lines are connected using quick-release couplings that are released by pressing in a retaining ring. Fuel hoses on the engine can only be secured with spring clamps. The use of clamps or threaded...

Removal and installation the fuel pump
Premise The ignition must be turned off and the key removed from the ignition switch. The fuel tank can be filled to a maximum of 1/2 full. Removal Empty the fuel tank if necessary. Remove the cover under the rear seat....

Removal and installation the fuel gauge sensor «G»
Remove the fuel pump. Unlock and remove the plug connectors of wires "3" and "4". Using a screwdriver, lift the retaining plates "1" and "2" and remove the fuel gauge sensor "G" in the downward direction "arrow"....

Pumping fuel out of the fuel tank
Important: If the fault is in the fuel pump, the fuel is sucked out using a fuel suction device. The ignition must be turned off and the key removed from the ignition switch. Remove the rear bench seat. Remove the fuel...

Removal and installation the fuel tank
The ignition must be turned off and the key removed from the ignition switch. Empty the fuel tank if necessary. After opening the lid, unscrew the threaded plug of the fuel tank filler neck. Remove the plastic cover of...

Fuel pump shutdown by crash signal
Mode of action Cars with airbags are equipped with a device to shut off the fuel pump with a crash signal (shock signal). If the Airbag system modules are activated while the vehicle is moving, the fuel pump is switched...

Electronic fuel management system (without mechanical connection of the accelerator pedal to the throttle valve)
Accelerator pedal module assembly diagram 1 - Bearing housing (support bracket); 2 - Plug connector, black, six-pin; 3 - Accelerator pedal module, with accelerator pedal position sensor "G79" and accelerator pedal...

Ventilation system with activated carbon
Assembly diagram of the activated carbon tank system Important: Hose connections are secured with spring clamps. To install spring clamps, it is recommended to use spring clamp pliers. 1 - Intake gas pipeline; 2 - Air...

Fuel injection system repair
Assembly location diagram The parts marked with letters A and B are not shown in the figure. A - Accelerator pedal position sensor "G79" and accelerator pedal position sensor 2 "G185", in the footwell on the accelerator...

Removal and installation of exhaust system components
Important: When carrying out assembly work on the exhaust system, ensure that the exhaust system is mounted without pre-tensioning and that sufficient distance between the system and the body is maintained. If...

Ignition system
Assembly diagram of ignition system components 1 - Plug connector, black, four-pin; 2 - Ignition coils with final power stage N70, N127, N291 and N292; 3 - Plug connector, black, two-pin, knock sensor 1 "G61",...

Removal and installation ignition coils with final power stages
Attach the puller to the ignition coil with the power output stage in the direction of the arrow. Pull the ignition coil with the power output stage out slightly. Install the installation tool as shown in the image....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Power and control system Skoda Rapid 1 (2012-2022)
➧ Power unit: Fuel system Skoda Octavia 1 (1996-2004)
➧ Power unit: Power and exhaust system Skoda Superb 2 (2008-2015)
➧ Power unit: Power and control system Skoda Yeti (2009-2017)
➧ Power unit: Fuel and exhaust system Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)