Cooling and lubrication system (diesel, 1.4 l) of Skoda Fabia 2

Assembly diagram of the lubrication system
Assembly diagram of the lubrication system Important: If, during engine repair, metal shavings or abraded metal particles are found in the oil in increased quantities, then, in order to avoid further damage, in addition...

Removal and installation the oil pan
Remove the lower engine cover. For engines with letter designations BNM, BNV Remove the downpipe bracket for the boost air intake. For all cars Drain the engine oil. Remove the oil pan/gearbox screw. Turn the crankshaft...

Removal and installation the balance shaft
Remove the timing belt. Remove the oil pan. Remove the flange gasket on the pulley side. Unscrew the screws securing the casing. Remove the casing from the mounting frame. Lock the chain tensioner using balancing...

Cooling system
Components of the cooling system located on the body 1 - Radiator, after replacement, refill the entire filling volume of coolant; 2 - O-ring seal, replace; 3 - Upper coolant hose, secured to the radiator with clamps; 4...

Coolant hose wiring diagram
For engines with letter designations BNM, BNV BNM, BNV 1 - Equalizing tank; 2 - Intake gas pipeline; 3 - Cylinder block/cylinder head; 4 - Heating system heat exchanger; 5 - Cooler of the recirculation system Or; 6 -...

Draining and filling coolant
Caution: When opening the expansion tank, hot steam may leak out. After covering the cork with a rag, carefully open it. Open the coolant cap on the expansion tank. Remove the lower engine cover. Place a catch basin...

Removal and installation the radiator
Remove the front bumper. Remove the main front headlights. Drain the coolant. Disconnect plug connector "1" from coolant fan thermal switch "F18" and disconnect plug connector "2" on the fan shroud. Disconnect the...

Removal and installation the liquid cooling system pump
Important: Seals and O-rings must always be replaced. To protect the timing belt from coolant, cover it with a rag before removing the water pump. Drain the coolant. Remove the timing belt. After unscrewing the...

Removal and installation the coolant temperature regulator
Important: Seals and O-rings must always be replaced. Drain the coolant. Remove the alternator. Disconnect the coolant hose from the connecting pipe. After unscrewing the locking screws "1" of the connecting pipe "2",...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Cooling system Skoda Rapid 1 (2012-2022)
➧ Petrol engines 1.2 l: Cooling system Skoda Octavia 3 (2013-2019)
➧ Power unit: Cooling system Skoda Superb 2 (2008-2015)
➧ Power unit: Cooling system (petrol 1.4 l) Skoda Kodiaq 1 (2016-2024)
➧ Power unit: Cooling system Skoda Yeti (2009-2017)
➧ Power unit: Cooling and heating Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)