Cardan shaft of car Skoda Fabia 2

Cardan shafts with constant velocity joints
Assembly diagram of a cardan shaft with a constant velocity joint Important: When replacing the protective cuff, the hinge should be additionally lubricated with consistent grease, if necessary. The added lubricant...

Removal and installation the propeller shaft mounting nut
Important: When loosening the driveshaft mounting nut, the bearing must not be under load. If the wheel hub bearings are loaded by the weight of the unladen vehicle, they will be damaged. This reduces the service life...

Removal and installation the outer joint of the propeller shaft
Loosen the twelve-sided nut for securing the cardan shaft. Remove the front wheel. Unscrew the "arrow" screws. Remove the ball joint "1" with the wheel bearing housing cover from the lower arm "2.". Fold the wheel hub...

Removal and installation the propeller shaft
Loosen the twelve-sided nut for securing the cardan shaft. Remove the front wheel. Remove the lower engine cover. Unscrew the cardan shaft from the shaft with the gearbox flange; if necessary, remove the protective...

Repair of a cardan shaft with a constant velocity joint
Removal the outer hinge, complete Remove the propeller shaft. Remove the protective cuff. Remove the protective sleeve of the joint and separate the cardan shaft joint with a strong blow from a plastic hammer. Remove...

Constant velocity joint control
Disassembly, inspection and assembly of the outer hinge The joint must be disassembled when replacing the filled grease, in case of significant contamination, or when checking the running balls for wear and damage....

Disassembly, inspection and assembly of the inner joint
The joint must be disassembled when replacing the filled grease, in case of significant contamination, or when checking the raceways of the support balls for wear and damage. Important: The hub and joint are mated...

Tripod constant velocity joint cardan shaft
Assembly diagram of a cardan shaft with a constant velocity joint "Tripod"- "AAR2000" Important: When replacing the protective cuff, the hinge should be additionally lubricated with consistent grease, if necessary. When...

Repair of a cardan shaft with a constant velocity joint «Tripod» — «AAR 2000»
Disassembly of the constant velocity joint "Tripod" - "AAR 2000" Remove the propeller shaft. Disconnect the hose clamp on the hinge element. Using a screwdriver, straighten the connecting parts made of sheet metal...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)