Automatic transmission 09G car Skoda Fabia 2

Gearbox markings
Gearbox markings The six-speed automatic transmission 09G is mounted in combination with four-cylinder engines. Location of letter markings on the gearbox Letter designation and design data of the gearbox "arrow 1" and...

Filling volume
Planetary gearbox Filling volume Automatic transmission 09G New gas station 6.0-6.1 l Change approx. 4.0-4.5 l 1) 1) Refueling for the entire service life: change only after repair. In the 09G automatic transmission,...

Gearshift mechanism repair
Gear shift control Caution: Before performing any work with the engine running, move the preselector lever to the "P" position and tighten the brake lever. In the positions of the preselector lever "S", "D", "R" and in...

Control and adjustment of the preselector lever cable tightening
Move the preselector lever to position "P". Remove the engine cover. Disconnect the plug connector from the automatic transmission control unit "J217". Remove the battery and battery holder. Remove the air intake...

Gearshift Mechanism Disassembly and Assembly — Overview
Important: The areas under the bushings and sliding surfaces must be lubricated with grease "G 000 450 02". There is no mechanical safety device with a drawbar to prevent the ignition key from being removed, but an...

Removal and installation the gearshift housing
With the ignition off, disconnect the wire connecting the battery terminal to the ground (body) of the vehicle. Pull the preselector lever handle button to the extreme position; the button will remain fixed here. Lift...

Removal and installation the gear shift mechanism
With the ignition off, disconnect the wire connecting the battery terminal to the ground (body) of the vehicle. Remove the gear shift cover. Remove the middle panel. Disconnect plug connectors "A" and "B". Remove the...

Removal the gearbox
Remove the engine cover. Important: If you disconnect and then reconnect the wire that connects the battery terminal to the vehicle ground (body), you will need to perform some additional work. All cable glands that...

Checking and refilling the ATF fluid level
The gearbox must not be in emergency mode. The car is in a horizontal position. Place the preselector lever in position "P" and leave the engine idling. The air conditioner and heater are turned off. The VAS 5051...

Topping up ATF fluid
By screwing in the quick-release coupling "VAS 6262/2" instead of the threaded plug for checking the gearbox "arrow 1", attach the adapter for filling with oil "VAS 6262". Add 1 liter of ATF fluid. Remove the "VAS 6262"...

Removal and installation the ATF cooler
Remove the engine cover. Remove the air intake sleeve. Label the ATF cooler hoses according to the ATF cooler to avoid confusion during reinstallation. Important: Depending on the design condition, there is a plastic...

Removal and installation a wiring harness with a 14-pin plug connector
A - 14-pin plug connector B - Wiring harness for 14-pin plug connector Removal the wiring harness with a 14-pin plug connector With the ignition off, disconnect the wire connecting the battery terminal to the ground...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)