Note: The "new" mechatronics unit for the gearbox is already filled with oil at the factory, do not drain the oil. The "removed" mechatronics unit is returned filled with oil (plug the vent with a suitable plug). When handling the mechatronics, ensure ventilation. When performing installation work, remove the ventilation plug and seal the hole with a suitable plug. If oil leaks from the mechatronics, the mechatronics must be replaced.
1. Screw, 10 Nm: 3 pcs., M8 x 35, for fastening the mechatronics of the DSG gearbox "J743" to the gearbox housing; replace
2. Screw, 10 Nm: 4 pcs., M8 x 90, for fastening the mechatronics of the DSG gearbox "J743" to the gearbox housing; replace
3. Mechatronics for dual clutch gearbox "J743"
Cover over the release levers
The cover protects against dirt. Tightening torque of the mounting screws: 8 Nm
Sequence and tightening torque of the Mechatronic unit mounting screws
Note: Replace screws.
Material published on the website www.SkodaBook.ru
Tighten the new mechatronics mounting screws in 4 stages as follows:
 |
 |